About Joyetech eGo One CLR Atomizer Head 5pcs
Joyetech is offering you electronic cigarette and e-liquid products too. They bring in a ton of VG and PG flavors too. Everything is easy to carry, and the company releases a plethora of e-cig kits for your convenience like Atopack Penguin, eVic VT, Primo and AIO, as well as Cuboid, UNIMAX and many others.
The Ego One is one of the most popular atomizer heads available on the market today. It can deliver a smooth inhale process and it is produced using a nickel and titanium coil. Over 200 coils are built into every atomizer for advanced temperature control. The v2 direct output on this device offers dual circuit protection and safety guards. The airflow system here is impeccable.
5pcs Joyetech eGo One CLR Atomizer Head
Product introduction
5pcs Joyetech eGo One CLR Atomizer Head is the specially designed atomizer head for Joyetech eGo One. With CLR head, you’re able to rebuild it while performance diminishing. Get it to enjoy vape and DIY fun!Parameters
Height: 18mm
Diameter: 10mm
Pre-made coil resistance: 1.0ohm, 0.5ohm
Pre-made coil diameter: 0.4mm
Suggested coil resistance: more than 0.3ohm
- 1 x 5pcs Joyetech eGo One CLR Atomizer Head
Detailed Instructions
FeaturesHigh quality
Delicate design
Operation Guide
Operation Steps
1.Prepare the heating wire. Standard heating wire for example. Take a piece of heating wire of around 60millimeters long and roll the heating wire; Reserve around 8.5mm on one side, and then rotate 5 - 6 circles reserving around 7mm on the other side. Bend a little at bot ends.
2.Install the regulating ring to the atomizer tube and screw it tightly. This ring could adjust the amount of liquid entering.
3.Put the heating wire into the tube, and keep it in the center position.
4.Put the long end into notch, pass the short end through the insulating ring.
5.Install the insulating ring and connection base to the tube.
6.Adjust the position of the heating wire and make the cotton cross the heating coil, cut off the redundant cotton to keep flush with liquid entering notches.
7.Screw on the top cap tightly.
Remark: please drip a few drops of e-juice on the cotton and make sure it is moist before the first use, or it will burn.
Order Tips
- It’s only suitable for Joyetech eGo One.
Related Products
Joyetech eGo One CLR VT Atomizer Head 5pcs
$16.76
Ex Tax: $16.76
Joyetech eGo One CL VT Atomizer Head 5pcs
$15.05
Ex Tax: $15.05
Joyetech eGo ONE Atomizer Head 5pcs
$19.09
Ex Tax: $19.09
Joyetech CL Pure Cotton Head 5pcs
$18.69
Ex Tax: $18.69
Joyetech ProCL Head for eGo ONE/TRON Series 5pcs
$25.70
Ex Tax: $25.70